These 6000 PSI Hotsy and Legacy pressure washer hoses are designed to be tough! Their abrasion resistant exterior offers protection against use over rough surfaces, such as asphalt and gravel. And the dual wire braided reinforcement provides durability and flexibility for an extended life. For customers who seem to be replacing hoses faster than normal, most typically caused by abuse such as dragging the hoses over gravel, leaving them laying on shop floors in fluids, etc., we recommend purchasing a two-wire braid hose. The extra layer of steel wire reinforcement allows for a longer high pressure hose life. This industrial grade pressure washer hose can be used on nearly all brands of hot water pressure washers, with a 3/8 inch MPT solid fitting on one end, a 3/8 inch MPT swivel fitting on the opposite end, and rated at up to 275 degrees F.
These 6000 PSI dual wire braid power washer replacement hoses are recommended for use on pressure washers over 3500 PSI. If your power washer is 3000 PSI or less, you may wish to consider purchasing our
4000 PSI single wire braid hose.