 |
Pressure Washer Pump Water Seals are a wear item in any high pressure pump because of the intense pressure they are subjected to. The new technology of these U-Seals withstands temperatures up to 185 degrees F while providing greater support to the seals. The end result is a high-performance pump with extended seal life.
This 8.725-362.0 Water Seal Kit is manufactured for Hotsy, Landa, Karcher and Legacy Pumps and includes: 3 high pressure seals, 3 low pressure seals, 6 backing / seal support rings, 3 teflon support rings, 3 o-rings.
THIS KIT DOES NOT INCLUDE BRASS PRESSURE RING OR BRASS INTERMEDIATE RING. If the brass pressure or intermediate rings show sign of damage or wear, please purchase the Hotsy Complete Seal Kit shown below.
Pump "U" Seal Kit, 20mm
This seal kit is designed for use in the following pump models:
HOTSY: H300, H300A, H300R, H400, H400A, H400R, HC165, HC165R, HC215, HC235, HC240, HC280, HC450, HC450A, HC450R, HC460, HC460AL, HC460AR, HC460L, HC460R, HC500, HC500A, HC500R, HHC300AR, HHC500AR, HH306R.1,HH306R.2, HH406R.1, HH406R.2, HHC456R.1, HH4546R.2, HHC466R.1, HHC466L.1, HH466R.2, HHC506R.1, HH506R.2
LANDA: LM-4030, LM-5030
KARCHER: KM4030.2, KM4030.3
LEGACY: GM4030.2, GM4030.3, GM5030.2, GM5030.3,
REPLACES PART NUMBERS: 87253620, 70-260036
PLEASE NOTE: U" Seals are NOT Directly Interchangeable with "V" Seals.
Should your Hotsy pump use a "V" Seal design please consult our "Hotsy Pump V Seal Selection Chart
|
|
 |